LEMON Manuals: Even more car manuals for everyone

Diagnosis Procedure

  1. CHECK TORQUE SENSOR POWER SUPPLY CIRCUIT
    1. Turn ignition switch OFF to ON.
      CAUTION: Never start the engine.
    2. Check voltage between torque sensor harness connector terminals and ground.
    CAUTION: Steering wheel is neutral position. (There is no steering force.)
    VOLTAGE REFERENCE CHART

    Torque sensor - Voltage
    Connector Terminal
    M327 13 Ground Approx. 5 V

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Perform the trouble diagnosis for battery power supply circuit. Refer to "DIAGNOSIS PROCEDURE ".

  2. CHECK TORQUE SENSOR GROUND CIRCUIT
    1. Turn ignition switch OFF.
    2. Check continuity between torque sensor harness connector terminal and ground.
      CAUTION: Steering wheel is neutral position. (There is no steering force.)
    CONTINUITY REFERENCE CHART

    Torque sensor - Continuity
    Connector Terminal
    M327 15 Ground Existed

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: Repair open circuit or short to ground or short to power in harness or connectors.

  3. CHECK TORQUE SENSOR SIGNAL
    1. Turn ignition switch OFF to ON.
    2. Check continuity between torque sensor harness connector terminal and ground.
    CAUTION: Steering wheel is neutral position. (There is no steering force.)
    CONTINUITY REFERENCE CHART

    Torque sensor - Continuity
    Connector Terminal
    M327 14 Ground Approx. 2.5 V
    16

    Is the inspection result normal? 

    YES: GO TO 4.

    NO: Torque sensor is malfunction. Replace steering column assembly. Refer to "EXPLODED VIEW ".

  4. CHECK CONNECTOR
    1. Turn ignition switch OFF.
    2. Disconnect torque sensor harness connector.
    3. Check terminal for deformation, disconnection, looseness, and so on. If any malfunction is found, repair or replace terminal.

    Is the inspection result normal? 

    YES: Replace EPS control unit. Refer to "EXPLODED VIEW ".

    NO: Repair or replace error-detected parts.