LEMON Manuals: Even more car manuals for everyone

Removal and Installation: Removal

  1. Remove front door finisher. Refer to "FRONT DOOR ".
  2. Temporarily reconnect the battery and the power window switch. Fully close front door window.
  3. Disconnect the battery negative terminal and remove the power window switch.
  4. Remove the front door sealing screen.
    NOTE: If the sealing screen is to be reused, pull it and the adhesive at approximately a 30 degree angle from the metal to remove it cleanly.
  5. Remove front door rear glass run channel. Refer to "FRONT DOOR GLASS AND REGULATOR ".
  6. Remove the door side grommet, and the door key cylinder mask (escutcheon) bolt.
  7. Disconnect the key cylinder connecting rod (key cylinder side).
  8. If equipped, disconnect the door antenna, the door request switch connector and remove the harness clamp. (Vehicle with intelligent key systems only).
    Fig 1: Identifying Door Key Cylinder Bolt
    G04888264
  9. Remove the door cylinder and mask assembly while pulling the outside handle forward.
    Fig 2: Pulling Outside Handle Forward
    G04888266
  10. Pull the outside door handle out and then slide it toward the rear of the vehicle to remove.
    Fig 3: Pulling Outside Door Handle Forward
    G04888267
  11. Remove the front and rear gaskets.
    Fig 4: Identifying Front And Rear Gaskets
    G04927725
  12. Remove the door lock assembly bolts.

    5.8 N.m (0.6 kg-m, 51.4 in-lb) 

    Fig 5: Locating Door Lock Assembly Bolts
    G04927726
  13. Slide the outside handle bracket toward the rear of the vehicle, and remove the assembly.
    Fig 6: Locating Outside Handle Bracket
    G04927727
  14. If equipped, disconnect the door lock assembly electrical connector.
  15. Separate the outside handle cable from the outside handle bracket.
    Fig 7: Separating Outside Handle Cable From Outside Handle Bracket
    G04888272