LEMON Manuals: Even more car manuals for everyone

Dual Proportioning Valve: Inspection

WARNING: This page is about a different car, the 2005 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Carefully monitor brake fluid level at master cylinder.
  • Use new brake fluid. Refer to "RECOMMENDED FLUIDS AND LUBRICANTS ".
  • Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on paint areas, wash it away with water immediately.
  1. Connect Tool to air bleeders of front and rear brakes on either LH and RH side.
    Fig 1: Connecting Tool To Air Bleeders Of Front And Rear Brakes On Either LH And RH Side
    G02523141Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Bleed air from the Tool.
  3. Check fluid pressure by depressing brake pedal.

    Applied pressure (Front brake) : 7, 355 kPa (75 kg/cm2, 1, 067 psi) 

    Output pressure (Rear brake) : 5, 100 - 5, 492 kPa (52 - 56 kg/cm2, 739 - 796 psi) 

    If output pressure is out of specification, replace dual proportioning valve.

  4. Bleed air after disconnecting the Tool. Refer to "BLEEDING BRAKE SYSTEM ".
    Fig 2: Checking Brake Fluid Pressure
    G02523142Courtesy of NISSAN MOTOR CO., U.S.A.