LEMON Manuals: Even more car manuals for everyone

Consult-II Basic Operation

WARNING: This page is about a different car, the 2004 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
  1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn ignition switch ON.
    Fig 1: Data Link Connector
    G02888467Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Touch "START (NISSAN BASED VHCL)".
    Fig 2: Scan Tool Display "CONSULT II"
    G02888468Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Touch "IPDM E/R" on "SELECT SYSTEM" screen.
    • If "IPDM E/R" is not displayed, print "SELECT SYSTEM" screen, then refer to
      Fig 3: Scan Tool Display "Select System"
      G02888469Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Select "SELF-DIAG RESULTS" or "DATA MONITOR".
    Fig 4: Scan Tool Display "Select Diag Mode"
    G02888470Courtesy of NISSAN MOTOR CO., U.S.A.