LEMON Manuals: Even more car manuals for everyone

Auto Light Sensor System Inspection

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
  1. OUTPUT SIGNAL INSPECTION 

    Select "BCM" in CONSULT-II. Using "OPTICAL SENSOR" data from "DATA MONITOR", check difference in the voltage when the auto light sensor is illuminated and not illuminated.

    Illuminated 

    Light sensor: 3.1V or more 

    Not illuminated 

    Light sensor: 0.6V or less 

    Fig 1: Displaying DATA MONITOR Mode
    G02849941Courtesy of NISSAN MOTOR CO., U.S.A.
    NOTE: If the auto light sensor is insufficiently illuminated, the measured value may not satisfy the standard.

    OK or NG

    1. OK: Normal.
    2. NG: GO TO 2.
  2. POWER SUPPLY CIRCUIT CONTINUITY INSPECTION 
    1. Disconnect connectors of BCM and auto light sensor.
    2. Check harness continuity between BCM vehicle-side connector terminal 45 (R) and vehicle-side connector terminal 1 (R) of auto light sensor.

      Continuity should exist. 

    3. Check continuity between BCM vehicle-side connector terminal 45 (R) and body ground.

      Continuity should not exist. 

      Fig 2: Checking Harness Continuity Between BCM Vehicle-Side Connector Terminal 45 (R)
      G02849942Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG

      1. OK: GO TO 3.
      2. NG: Malfunction in harness between BCM and auto light sensor. Repair or replace as required.
  3. OUTPUT CIRCUIT CONTINUITY INSPECTION 
    1. Check harness continuity between BCM vehicle-side connector terminal 38 (W/R) and vehicle-side connector terminal 2 (W/R) of auto light sensor.

      Continuity should exist. 

    2. Check continuity between BCM vehicle-side connector terminal 38 (W/R) and body ground.

      Continuity should not exist. 

      OK or NG

      1. OK: GO TO 4.
      2. NG: Malfunction in harness between BCM and auto light sensor. Repair or replace as required.
        Fig 3: Checking Continuity Between BCM Vehicle-Side Connector Terminal 38 (W/R) And Body Ground
        G02849943Courtesy of NISSAN MOTOR CO., U.S.A.
  4. GROUND CIRCUIT CONTINUITY INSPECTION 
    1. Check harness continuity between BCM vehicle-side connector terminal 53 (P) and vehicle-side connector terminal 3 (P) of auto light sensor.

      Continuity should not exist. 

    2. Check continuity between BCM vehicle-side connector terminal 53 (P) and body ground.

      Continuity should not exist. 

      Fig 4: Checking Harness Continuity Between BCM Vehicle-Side Connector Terminal 53 (P)
      G02849944Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG

      1. OK: GO TO 5.
      2. NG: Malfunction in harness between BCM and auto light sensor. Repair or replace as required.
  5. SENSOR VOLTAGE INSPECTION 
    1. Connect BCM connector.
    2. Check voltage between BCM terminal 45 (R) and body ground.

      Approx. 5V 

      OK or NG

      1. OK: Replace the auto light sensor.
      2. NG: Replace BCM.
        Fig 5: Checking Voltage Between BCM Terminal 45 (R) And Body Ground
        G02849945Courtesy of NISSAN MOTOR CO., U.S.A.