LEMON Manuals: Even more car manuals for everyone

Diagnostic Procedure

  1. CHECK VIAS CONTROL SOLENOID VALVE POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect VIAS control solenoid valve harness connector.
    3. Turn ignition switch ON.
      Fig 1: Identifying VIAS Control Solenoid Valve
      G02884872Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Check voltage between terminal 1 and ground with CONSULT-II or tester.

      Voltage: Battery voltage 

    OK or NG

    1. OK : GO TO  3.
    2. NG : GO TO 2.
      Fig 2: Checking Voltage Between VIAS Terminal 1 & Ground
      G02884873Courtesy of NISSAN MOTOR CO., U.S.A.
  2. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors E20, F32
    • IPDM E/R connector E122
    • 10 A fuse
    • Harness for open or short between IPDM E/R and VIAS control solenoid valve
    1. : Repair or replace harness or connectors.
  3. CHECK VIAS CONTROL SOLENOID VALVE OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check harness continuity between ECM terminal 29 and VIAS control solenoid valve terminal 2. Refer to Wiring Diagram .

      Continuity should exist. 

    4. Also check harness for short to ground and short to power.

    OK or NG

    1. OK : GO TO 4.
    2. NG : Repair open circuit or short to ground or short to power in harness or connectors.
  4. CHECK VIAS CONTROL SOLENOID VALVE 

    Refer to "COMPONENT INSPECTION ".

    OK or NG

    1. OK : GO TO 5.
    2. NG : Replace VIAS control solenoid valve.
  5. CHECK INTERMITTENT INCIDENT 

    Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

    1. >> INSPECTION END