LEMON Manuals: Even more car manuals for everyone

Diagnostic Procedure

  1. CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect intake valve timing control solenoid valve harness connector.
    3. Turn ignition switch ON.
      Fig 1: Identifying Intake Valve Timing Control Solenoid Valve
      G02884596Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Check voltage between intake valve timing control solenoid valve terminal 2 and ground with CONSULT-II or tester.

      Voltage: Battery voltage 

    OK or NG

    1. OK : GO TO  3.
    2. NG : GO TO 2.
      Fig 2: Checking Voltage Between Intake Valve Timing Control Solenoid Valve Terminal 2 & Ground
      G02884597Courtesy of NISSAN MOTOR CO., U.S.A.
  2. DETECT MALFUNCTION PART 

    Check the following.

    • Harness connectors E20, F32
    • Harness for open or short between intake valve timing control solenoid valve and I RDM E/R
      1. : Repair or replace harness or connectors.
  3. CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check harness continuity between ECM terminal 11 and intake valve timing control solenoid valve terminal 1. Refer to Wiring Diagram .

      Continuity should exist. 

    4. Also check harness for short to ground and short to power.

    OK or NG

    1. OK : GO TO 4.
    2. NG : Repair open circuit or short to ground or short to power in harness or connectors.
  4. CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE 

    Refer to "COMPONENT INSPECTION ".

    OK or NG

    1. OK : GO TO 5.
    2. NG : Replace intake valve timing control solenoid valve.
  5. CHECK INTERMITTENT INCIDENT 

    Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

    1. >> INSPECTION END