LEMON Manuals: Even more car manuals for everyone

Door Lock/Unlock Switch Check

  1. CHECK DOOR LOCK/UNLOCK SWITCH INPUT SIGNAL 

    With CONSULT-II 

    Check door lock/unlock switch ("LOCK SW DR/AS"/"UNLK SW DR/AS") in "DATA MONITOR" mode with CONSULT-II.

    Fig 1: Checking Door Lock/Unlock Switch Input Signal With CONSULT-II
    G01332932Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-II 

    1. Disconnect smart entrance control unit harness connector.
    2. Check continuity between smart entrance control unit harness connector terminal 23 or 35 and ground.
      Fig 2: Checking Door Lock/Unlock Switch Input Signal Without CONSULT-II
      G01332933Courtesy of NISSAN MOTOR CO., U.S.A.

    Refer to "FIG. 3  ".

    OK or NG

    OK : Door lock/unlock switch is OK.

    NG : GO TO 2.

  2. CHECK DOOR LOCK/UNLOCK SWITCH 
    1. Disconnect door lock/unlock switch harness connector.
    2. Check continuity between each door lock/unlock switch terminals.
    • Main power window and door lock/unlock switch
      Fig 3: Checking Door Lock/Unlock Switch (Main Power Window And Door Lock/Unlock Switch)
      G01332934Courtesy of NISSAN MOTOR CO., U.S.A.
    • Door lock/unlock switch RH
      Fig 4: Checking Door Lock/Unlock Switch (RH)
      G01332935Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG

    OK : Check the following.

    • Ground circuit for door lock/unlock switch
    • Harness for open or short between door lock/unlock switch and smart entrance control unit connector

    NG : Replace door lock/unlock switch.