Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ATP SWITCH SIGNAL
With CONSULT-II
- Start engine.
- Select "DATA MONITOR" mode for "ALL MODE AWD/4WD" with CONSULT-II.
- Read out the value of "ATP SWITCH".VEHICLE SPEED CONDITION
Condition Display value - Vehicle stopped
- Engine running
- A/T selector lever "N" position with brake pedal depressed.
4WD shift switch: 4H to 4LO or 4LO to 4H (While actuator motor is operating.) ON Except the above OFF
Without CONSULT-II
- Start engine.
- Check voltage between transfer control unit harness connector terminal and ground.CONNECTOR TERMINAL VOLTAGE SPECIFICATION
Connector Terminal Condition Voltage (Approx.) M152 23 - Ground - Vehicle stopped
- Engine running
- A/T selector lever "N" position with brake pedal depressed.
4WD shift switch: 4H to 4LO or 4LO to 4H (While actuator motor is operating.) 0V Except the above Battery voltage
OK or NG
- OK: GO TO 5.
- NG: GO TO 2.
- CHECK HARNESS BETWEEN TRANSFER CONTROL UNIT AND ATP SWITCH
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Disconnect transfer control unit harness connector and the ATP switch harness connector.
- Check continuity between transfer control unit harness connector M152 terminal 23 and ATP switch harness connector F55 terminal 8.
Continuity should exist .
Also check harness for short to ground and short to power.
OK or NG
- OK: GO TO 3.
- NG: Repair or replace damaged parts.
- CHECK GROUND CIRCUIT
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Disconnect ATP switch harness connector.
- Check continuity between ATP switch harness connector F55 terminal 9 and ground.
Continuity should exist .
Also check harness for short to power.
OK or NG
- OK: GO TO 4.
- NG: Repair open circuit or short to power in harness or connectors.
- CHECK ATP SWITCH
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Remove ATP switch. Refer to , "LOCATION OF ELECTRICAL PARTS ".
- Push and release ATP switch and check continuity between ATP switch terminals 8 and 9.CONNECTOR TERMINAL CONTINUITY SPECIFICATION
Terminal Condition Continuity 8 - 9 Push ATP switch Yes Release ATP switch No
OK or NG
- OK: GO TO 5.
- NG: Replace ATP switch. Refer to , "LOCATION OF ELECTRICAL PARTS ".
- CHECK TRANSFER CONTROL UNIT
Check transfer control unit input/output signal. Refer to , "TRANSFER CONTROL UNIT INPUT/OUTPUT SIGNAL REFERENCE VALUES ".
OK or NG
- OK: GO TO 6.
- NG: Check transfer control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.
- CHECK ATP WARNING LAMP
- Turn ignition switch "ON". (Do not start engine.)
- A/T selector lever "N" position and engage the parking brake.
- Switch 4WD shift switch from 4H to 4LO or 4LO to 4H.
Does ATP warning lamp turn "ON", while actuator motor is operating?
- YES: Inspection End.
- NO: Go to , "ATP Warning Lamp Does Not Turn ON ".