LEMON Manuals: Even more car manuals for everyone

Steering Gear Turning Torque

  1. Remove steering gear from vehicle and attach gear to Mounting Plate (KV48100301 ). Install mounting plate in soft-jawed vise. Install Torque Adapter (KV48100700 ) and INCH-lb. torque wrench to worm gear stub shaft. Turn worm gear stub shaft fully left and right several times. Set steering gear to straight-ahead (neutral) position. Steering gear straight-ahead (neutral) position is 2.14 turns of stub shaft from full lock position.
  2. Turn stub shaft left and right 360 degrees from neutral position and measure turning torque at 360 degree position. On 2WD steering gear, turning torque should be 6.1-10.4 INCH lbs. (0.7-1.2 N.m). On 4WD steering gear, turning torque should be 1.3-6.9 INCH lbs. (0.14-0.78 N.m).
  3. Return steering gear stub shaft to neutral position and measure turning torque. On 2WD steering gear, turning torque should be 7.0-13.9 INCH lbs. (0.79-1.57 N.m). On 4WD steering gear, turning torque should be 2.2-11.7 INCH lbs. (0.25-1.32 N.m) greater than torque at 360 degrees with a maximum turning torque of 9.1-13.0 INCH lbs. (1.03-1.47 N.m). If measurement is not within specification, turn sector shaft adjusting screw.
  4. Loosen adjusting screw lock nut. Turn adjusting screw until correct turning torque is obtained. Tighten adjusting screw lock nut to specification. See TORQUE SPECIFICATIONS  table. If correct turning torque cannot be obtained, replace steering gear.