LEMON Manuals: Even more car manuals for everyone

DTC P1401: EGR Temperature Sensor

  1. Check Power Supply  - Turn ignition off. Disconnect EGR temperature sensor harness connector. See Fig 1. Turn ignition on. Using a voltmeter, measure voltage between ground and EGR temperature sensor harness connector terminal No. 1 (Green/Orange wire). If voltage is not about 5 volts, repair fault in Green/Orange wire. If voltage is about 5 volts, go to next step.
  2. Check Ground Circuit  - Turn ignition off. Using an ohmmeter, check continuity between engine ground and EGR temperature sensor harness connector terminal No. 2 (Black/Green wire). If no continuity exists, repair open in Black/Green wire. If continuity exists, go to next step.
  3. Check Component  - Reconnect all connectors. Start engine and allow to idle. As engine warms up, measure voltage across sensor connector terminals. See EGR TEMPERATURE SENSOR VOLTAGE table. If voltage is not as specified, replace sensor. If voltage is as specified, turn ignition off. Check ECM connector for damage or corrosion. Repair or replace as necessary.
EGR TEMPERATURE SENSOR VOLTAGE (1)

Temperature - °F (°C) Volts
32 (0) 4.81
122 (50) 2.82
212 (100) 0.8
(1) Voltage values are approximate.
Fig 1: Locating EGR Temperature Sensor Connector
G96C11470Courtesy of NISSAN MOTOR CO., U.S.A.