DTC P1165: Swirl Control Valve Control Vacuum Check Switch
- Check Swirl Control Vacuum Hoses - Turn ignition off. Check hoses between swirl control valve solenoid valve, swirl control valve control vacuum check switch and swirl control valve actuator for clogging, cracks or improper connection. See Figure. Repair or reconnect hoses as required. If hoses are okay go to next step.
- Check Ground Circuit - Turn ignition off. Disconnect swirl control valve control vacuum check switch harness connector. Using an ohmmeter, check continuity between switch harness connector terminal No. 1 (Black wire) and ground. If no continuity exists, repair open in Black wire. If continuity exists, go to next step.
- Check Input Signal Circuit - Turn ignition on. Using a voltmeter, measure voltage between switch harness connector terminal No. 2 (Red/Yellow wire) and ground. If voltage is not about 5 volts, repair fault in Red/Yellow wire. If voltage is about 5 volts, go to step 5) of DTC P1130: SWIRL CONTROL VALVE CONTROL SOLENOID VALVE.