LEMON Manuals: Even more car manuals for everyone

DTC P0120: Throttle Position (TP) Sensor

  1. Check Power Supply  - Turn ignition off. Disconnect TP sensor harness connector. See REMOVE/INSTALL/OVERHAUL for sensor location. Turn ignition on. Using a voltmeter, measure voltage between TP sensor harness connector terminal No. 1 (Pink wire) and ground. If voltage is not about 5 volts, repair fault in Pink wire circuit. If voltage is about 5 volts, go to next step.
  2. Check Ground Circuit  - Turn ignition off. Loosen and retighten engine ground bolts. See Figure. Using an ohmmeter, check continuity between TP sensor harness connector terminal No. 3 (Black/Green wire) and engine ground. If no continuity exists, repair open in Black/Green wire. If continuity exists, go to next step.
  3. Check Input Signal Circuit  - Turn ignition off. Disconnect ECM harness connector. See Figure. Using an ohmmeter, check continuity between ECM harness connect or terminal No. 23 and TP sensor harness connector terminal No. 2 (White wire). If no continuity exists, repair open in White wire. If continuity exists, go to next step.
  4. Check Component  - Leave TP sensor disconnected. While opening and closing throttle, check resistance across TP sensor connector terminal No. 2 (White wire) and No. 3 (Black wire). See Fig 1. See THROTTLE POSITION SENSOR RESISTANCE TEST table. If resistance is not as specified, adjust TP sensor. See ADJUSTMENTS article. If resistance is still not as specified after adjustment, replace TP sensor.
THROTTLE POSITION SENSOR RESISTANCE TEST (1)

Throttle Position Ohms
Fully Closed About 500
Partially Opened 500-4000
Fully Open About 4000
(1) Ensure resistance changes when opening and closing throttle.
Fig 1: Testing Throttle Position (TP) Sensor
G97C06116Courtesy of NISSAN MOTOR CO., U.S.A.