LEMON Manuals: Even more car manuals for everyone

DTC P0105: Absolute Pressure (AP) Sensor

  1. Check Power Supply  - Turn ignition off. Disconnect AP sensor harness connector. See Fig 1. Turn ignition on. Using a voltmeter, measure voltage between AP sensor harness connector terminal No. 3 (Pink wire) and engine ground. If voltage is about 5 volts, go to next step. If voltage is not about 5 volts, check for faulty joint connector No. 1 or fault in Pink wire. Repair or replace as required.
  2. Check Ground Circuit  - Turn ignition off. Loosen and retighten ground bolts. See Figure. Using an ohmmeter, check continuity between AP sensor harness c onnector terminal No. 1 (Black/Green wire) and ground. If no continuity exists, repair open in Black/Green wire. If continuity exists, go to next step.
  3. Check Input Signal Circuit  - Turn ignition off. Disconnect ECM harness connector. See Figure. Using an ohmmeter, check continuity between ECM harness connect or terminal No. 57 and AP sensor harness connector terminal No. 2 (Blue wire). If no continuity exists, repair open in Blue wire. If continuity exists, go to next step.
  4. Check Vacuum Source  - Start engine and allow it to warm up. Disconnect vacuum hose to AP sensor. Using a vacuum gauge, check vacuum at idle is about 19.69 inch Hg vacuum. If measured vacuum is as specified, go to next step. If measured vacuum is not as specified, check vacuum hose for clogging, cracks or improper connection. Check intake system for air leaks. Repair or replace as necessary.
  5. Turn ignition off. Check hose between AP sensor and MAP/BARO solenoid for clogging, cracks or improper connection. Repair or replace hose as required. If hose is okay, go to next step.
  6. Check Component  - Remove AP sensor and reconnect harness connector. Disconnect vacuum hose from AP sensor. Turn ignition on. Using a voltmeter, backprobe AP sensor harness connector terminal No. 2 (middle terminal). Measured voltage should be 3.2-4.8 volts.
  7. Apply vacuum of 7.9 in Hg. Measured voltage should be 1.0-1.4 volts less than voltage measured in previous step. If voltage is not as specified, replace AP sensor. If voltage is as specified, disconnect system harness connectors and inspect for damage or corrosion. Repair as necessary and retest.
Fig 1: Locating AP Sensor Harness Connector
G96I11468Courtesy of NISSAN MOTOR CO., U.S.A.