LEMON Manuals: Even more car manuals for everyone

Reassembly Service Points

>> A << SPACER, SIDE GEAR, WASHER, PINION, PINION SHAFT INSTALLATION 

  1. Install the spacers to the back side of the side gears, and then assemble the side gears into the differential case.
    Fig 1: Installing Side Gears
    G02680386
    NOTE: Select the medium size spacer[0.93-1.00 mm (0.0366 - 0.0394 in.)] when assembling a new side gear.
  2. Attach the washers to the back side of the pinions, engage the pinions simultaneously to the side gears, and settle the gears by turning.
  3. Insert the pinion shaft.
    Fig 2: Installing Pinion Shaft
    G02680387
  4. Measure the backlash between the side gears and pinions.
    Fig 3: Measuring Backlash Between The Side Gears And Pinions
    G02680388

    Standard value: 

    0.025 - 0.150 mm (0.00098 - 0.00591 in.) 

  5. If not within the standard value, change a spacer and measure the backlash again.
    NOTE: Adjust so that both backlashes are equal.

    >> B << LOCK PIN INSTALLATION 

  1. Install the chamfered side of the lock pin first.
    Fig 4: Installing Lock Pin
    G02680389

    >> C << TAPER ROLLER BEARING INSTALLATION 

    Fig 5: Installing Taper Roller Bearing
    G02680390

    >> D << DIFFERENTIAL DRIVE GEAR INSTALLATION 

    Apply ATF to the bolt, tighten the bolts to the specified torque in the shown sequence.

    Standard value: 132 Nm (98 ft.lbs.) 

    Fig 6: Installing Differential Drive Gear
    G02680391