Stall Speed Test: Notes
CAUTION:
During stall speed test, do not open throttle fully for more than 8 seconds or transaxle damage may occur. If performing more than one torque converter stall speed test, operate engine at 1000 RPM in Neutral for at least 2 minutes to cool transmission fluid before performing next stall speed test.
- Ensure transmission fluid and engine coolant levels are correct. Apply parking brake and chock both rear wheels. Connect a tachometer to engine. Start and run engine until transmission fluid temperature reaches 158-176°F (70-80°C) and engine coolant temperature reaches 176-212°F (80-100°C).
- Place gearshift lever in "D" position, open throttle fully, and note maximum engine RPM on tachometer. This is the torque converter stall speed. Stall speed should be 2100-2600 RPM.
- Repeat procedure with gearshift lever in "R" position. Stall speed should be 2100-2600 RPM. Stop engine and place gearshift lever in "P" position. If stall speed is as specified, testing is complete. If stall speed is not as specified, use the following symptoms for trouble shooting results of the stall speed test.