LEMON Manuals: Even more car manuals for everyone

Throttle Position Sensor

  1. Disconnect the TP sensor harness connector.
  2. Measure the resistance between the TP sensor terminals No. 1 and 4. See Figure. Resistance should be 3.5-6.5 k/ohms.
  3. Measure the resistance between the TP sensor terminals No. 3 and 4 while opening throttle slowly open until fully open from the idle position. Resistance changes smoothly in proportion to the opening angle of the throttle.
  4. If the resistance is outside the standard value, or does not change smoothly, replace the TP sensor. See REMOVAL, OVERHAUL & INSTALLATION article in ENGINE PERFORMANCE.