LEMON Manuals: Even more car manuals for everyone

Code 34: Steering Wheel Sensor St-1 Or St-2 Failure

NOTE: Code 34 may be output if vehicle tires are not equal size.
  1. Disconnect steering wheel sensor harness connector C-48. See Figure . Turn ignition on. Using DVOM, measure voltage between steering wheel sensor harness connector C-48 terminal No. 10 and ground. See Figure . If voltage is 4-5 volts, replace steering wheel sensor. See STEERING WHEEL SENSOR under REMOVAL & INSTALLATION.
  2. If voltage is not 4-5 volts on vehicles with Electronic Controlled Suspension (ECS), inspect and repair circuit between ECS control unit and steering wheel sensor. See appropriate wiring diagram in WIRING DIAGRAMS. If circuit is okay, replace ECS control unit and retest. See Figure .
  3. If voltage is not 4-5 volts on vehicles without ECS, inspect and repair circuit between TCL module and steering wheel sensor. See appropriate wiring diagram in WIRING DIAGRAMS. If circuit is okay, replace TCL module and retest. See Figure .