Hydraulic System Air Bleeding
- Ensure reservoir is filled before bleeding. Add fluid, as necessary, during bleeding. Raise and support vehicle. Disconnect coil high tension wire.
- While cranking engine, turn steering wheel lock-to-lock, 5 or 6 times. Lower vehicle. Install a hose approximately 20" long to bleeder screw of steering gear.CAUTION: DO NOT crank engine for more than 15-20 seconds.
- Place other end of hose in container. Connect coil wire. Start engine and let it idle. Turn steering wheel to left lock. Loosen bleeder screw. Repeat this until no more bubbles appear in container.
- Remove hose. Tighten bleeder screw. Check fluid level. Add fluid (if necessary). Turn steering wheel lock-to-lock. Fluid level should not change more than .12-.16" (3-4 mm). If it does, repeat bleeding procedure.