Bus System Gateway
The IKE provides a gateway for communication between the DS2-bus and K-bus, and between the CAN-bus and K-bus, translating the protocol used between the different systems. The K-bus uses a baud rate of 9600 bits per second and the CAN-bus uses a baud rate of 500 k/bits per second. This speed difference in communication rate makes it impossible for a component on the K-Bus to speak directly to a component on the CAN-Bus. The two components are talking different languages. The IKE is the translator, receiving messages, translating them into the proper language and relaying them.
EXAMPLES OF BUS INFORMATION TRANSMITTED AND RECEIVED BY IKE
| Information | Transmitted By | Received By | Bus System |
|---|---|---|---|
| EWS signal | EWS3 | IKE | K |
| Door open | BC1 | IKE | K |
| Gear Status | IKE | BC1, PDC | K |
| Ambient Temp | IKE | IHKA | K |
| Engine Speed | EMS2000 | IKE | CAN |
| Fuel Use | EMS2000 | IKE | CAN |
| Gear Position | GIU | IKE | CAN |
| Odometer | IKE | BC1 | CAN |
NOTE:
These are but a few examples of bus information handled by the IKE..