Clutch Assembly: Installation
- Lightly coat pilot bearing bore with Clutch Grease (C1AZ-19590-B ). Using clutch aligner and Pilot Bearing Replacer (T71P-7137-C ), install pilot bearing with sealed surface facing outward (if removed).
- DO NOT reuse pilot bearing, if removed for any reason. Lightly coat input shaft on transmission with Clutch Grease (C1AZ-19590-B
). Install transmission by reversing removal procedure.NOTE: Transmission fluid is a semi-synthetic oil. When adding or replacing, use ONLY E5RY-19C-547A (Ford specification ESD-M-2C175A ).
- To complete installation, reverse removal procedure. Tighten all bolts/nuts to specifications. Align all marks made at removal. Ensure driveshaft center bearing spacers are installed to original location and position as noted at removal. Check and fill transmission to proper level.