LEMON Manuals: Even more car manuals for everyone

Removal and Installation

All vehicles 

    NOTE: Module configuration is only required if a new ACM  is being installed.
  1. Upload the ACM  configuration to the scan tool. For additional information, Refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
  2. Remove the middle instrument panel center finish panel. For additional information, Refer to INSTRUMENT PANEL article.
  3. Remove the 4 ACM  screws.
    • To install, tighten to 2 Nm (18 lb-in) (navigation).
    • To install, tighten to 1 Nm (9 lb-in) (all except navigation).

    Navigation 

  4. Disconnect the antenna and electrical connectors.

    All except navigation 

  5. NOTE: Only carry out this step if installing a new ACM  .
  6. Remove the 2 ACM  brackets.

    All vehicles 

  7. Remove the ACM  .
  8. To install, reverse the removal procedure.
    • Download the configuration information to the ACM  . For additional information, Refer to PMI  in MODULE CONFIGURATION article.