LEMON Manuals: Even more car manuals for everyone

Test P: Abs Warning Indicator Shorted

DTC C1220 is generated when ABCM detects battery voltage to ABS warning indicator when ABS indicator should be on. Possible conditions include a burnt out ABS warning light bulb, shorted circuit or defective ABS light driver in ABCM.

  1. Check ABS Warning Light Prove Out

    Install scan tool. Turn ignition off, then turn ignition on while watching ABS warning light. If ABS warning indicator illuminated for about 2 seconds and then goes out, go to next step. If ABS indicator did not come on, or did not go out after 2 seconds, go to step 3)  .
  2. Verify ABCM Function

    Check for any DTCs. If DTC C1220 exists, replace ABCM and go to step 5)  . If DTC does not exist, go to step 5)  .
  3. Check For Short-To-Power

    Turn ignition off. Disconnect instrument panel connector C252. Install breakout box. Turn ignition on. Measure voltage between pins No. 33 and 60. If voltage is present, repair Yellow/Red wire, then go to step 6)  . If no voltage is present, connect instrument panel connector and go to next step.
  4. Isolate Fault

    Using a jumper wire, connect breakout box pins No. 60 (ground) and 33. Turn ignition on for 10 seconds, then turn ignition off. If ABS warning light illuminates brightly, replace ABCM, then go to step 6)  . If ABS warning illuminates dimly, repair Yellow/Red wire between ABCM and instrument panel connector, and go to step 6)  . If ABS indicator light did not illuminate, see appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT.
  5. Check Intermittent Wiring Concern

    Turn ignition off. Install breakout box. Remove (10-amp) METER fuse. Using DVOM, check voltage between breakout box pins No. 60 and 33. While monitoring DVOM reading, wiggle end points of wiring harness. Continue to wiggle harness working towards middle of harness. If voltage is detected, repair Yellow/Red wire circuit, then go to next step. If voltage is not detected, go to next step.
  6. Verify Repair

    Restore ABS system and connect all components. Clear DTCs. Perform DRIVE CYCLE TEST. Check for any DTCs. If SYSTEM PASS is obtained, repair is complete. If SYSTEM PASS is not obtained and original DTC is retrieved, go back to step 1)  . If different DTCs exist, see DTC TEST INDEX  table.