System Testing
- Turn ignition on. Turn on rear window defroster. If defroster does not work at all, go to next step. If rear window defroster works in some places but not in others, go to FILAMENT TESTING.
- Turn ignition on. Turn on rear window defroster. Observe indicator light. If light is not on, go to next step. If light is on, go to step 6).
- Inspect METER fuse. If fuse has failed, go to next step. If fuse is okay, go to step 6).
- Turn ignition off. Replace METER fuse. Turn ignition on. Turn on rear window defroster. If fuse fails, go to next step. If fuse does not fail, go to step 6).
- Turn ignition off. Unplug connectors from rear defroster switch and fuse panel. Measure resistance between Black/Yellow wire at fuse panel and ground. If resistance is not less than 5 ohms, go to next step. If resistance is less than 5 ohms, repair shorted Black/Yellow wire.
- Turn ignition off. Unplug connector from rear defroster switch. Measure resistance between Black wire at harness connector and ground. If resistance is not less than 5 ohms, go to next step. If resistance is less than 5 ohms, repair shorted Black wire.
- Turn ignition on. Check for battery voltage on Black/Yellow wire at rear defroster switch harness connector. If battery voltage exists, go to next step. If battery voltage does not exist, repair Black/Yellow wire.
- Turn ignition on. Measure voltage on Black/White wire at rear defroster switch. Battery voltage should exist with switch on, and less than one volt with switch off. If voltage is not as specified, go to next step. If voltage is as specified and indicator light is on, go to step 10). If voltage is as specified and indicator light is not on, replace rear defroster switch.
- Turn ignition off. Unplug rear window defroster switch. Measure resistance between Black/White and Black/Yellow wire terminals on switch. Resistance should be less than 5 ohms with switch on, and more than 10,000 ohms with switch off. Replace switch if resistance is not as specified.
- Turn ignition on. Measure voltage on Black/White wire at defroster relay, located at left rear of luggage compartment. Battery voltage should exist with defroster switch on, and less than one volt with switch off. If voltage is as specified, go to next step. If voltage is not as specified, repair Black/White wire.
- Unplug connector from rear defroster relay. Measure resistance between Black wire at harness connector and ground. If resistance is less than 5 ohms, go to next step. If resistance is not less than 5 ohms, repair open Black wire.
- Measure voltage on Black/Yellow wire at defroster relay. If battery voltage exists, battery voltage exists, go to step 14). If voltage is not as specified, go to next step.
- Inspect HTD B-LIGHT fuse. If fuse is okay, repair open Black/Yellow wire. Replace fuse if it has failed. If fuse fails again, inspect for shorted Black/Yellow wire. Repair as necessary.
- Unplug defroster relay. Connect battery voltage to relay terminal for Black/White wire terminal. Connect Black wire terminal to ground. Measure resistance between Black/Yellow wire terminals. If resistance is less than 5 ohms, go to next step. Replace relay if resistance is not as specified.
- Reconnect all wiring. Turn ignition on. Turn rear window defroster on. Measure voltage at Black/Blue wire at rear window defroster grid connector. If battery voltage exists, go to next step. If battery voltage does not exist, repair Black/Blue wire.
- Turn ignition off. Unplug connector from rear window. Measure resistance of Black wire between harness connector and ground. If resistance is less than 5 ohms, service window grid. See FILAMENT TESTING. If resistance is not less than 5 ohms, repair Black wire.