Remove/Install Crankshaft Hall Sensor - AR15.12-P-2136MNB
Engine 178 In Model 190
| Remove/install | |||
| 1 | Remove bottom Engine compartment lining. | Engine 178 in model 190.381 | AR61.20-P-1105RGB |
| Engine 178 in model 190 (except 190.381) | AR61.20-P-1105RG | ||
| 2 | Disconnect electrical connector (3). | ||
| 3 | Remove screw (2). | *BA15.10-P-1001-03M | |
| 4 | Remove crankshaft Hall sensor (1). | ||
| 5 | Install in the reverse order | ||
| 6 | Perform default initialization and then sensor rotor adaptation using vehicle diagnosis system. | When replacing the crankshaft Hall sensor (1) | |
| AD00.00-P-2000-04B | |||
| Risk of accident from vehicle starting off by itself when Engine running. Risk of injury (bruises and burns) resulting from working on the Engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. |
AS00.00-Z-0005-01A | |
| 7 | Perform an Engine test run and check the Engine for proper function. |
POSITION SENSOR
| Number | Designation | Engine 178 | |
|---|---|---|---|
| BA15.10-P-1001-03M | Bolt, crankshaft position sensor to crankcase | Nm | 8 |