LEMON Manuals: Even more car manuals for everyone

Remove/install starter - AR15.30-P-7100GZA

ENGINE 272, 273 in MODEL 164 

Shown on model 164.1 

Fig 1: Identifying Starter Remove/Install Components - Shown On Model 164.1
G10115377Courtesy of MERCEDES-BENZ USA
Fig 2: Identifying Starter Remove/Install Components
G10115378DANGERNOTESREMOVINGINSTALLINGNOTESTORQUE SPECIFICATIONIMPORTANTTORQUE SPECIFICATIONTORQUE SPECIFICATIONINSPECTIMPORTANTCourtesy of MERCEDES-BENZ USA
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
NOTES Notes on self-locking nuts and bolts   AH00.00-N-0001-01A
REMOVINGINSTALLING Remove/install     
1 Detach ground line from battery   AR54.10-P-0003GZ
NOTES Notes on battery   AH54.10-P-0001-01A
2 Remove bottom engine compartment paneling   AR61.20-P-1105GZ
3 Remove right catalytic converter   AR49.10-P-7100GZA
4 Unhook nuts (5m), heat shield (5) from bracket (5h) and take off    
5 Pry off cable bracket (1a) from transmission bracket    
6 Remove screw/bolts (4) from starter (M1) TORQUE SPECIFICATION Bolt, starter to crankcase *BA15.30-P-1003-01J 
7 Move starter (M1) out of transmission bell housing IMPORTANT First lower starter with attached lines to the rear, then to the front out of the transmission bell housing until the electrical connections are accessible.  
8 Detach cap (1) and detach lines from the electrical connections (2, 3) on starter (M1) TORQUE SPECIFICATION Nut, connection for terminal designation 30 *BA15.30-P-1001-01J 
TORQUE SPECIFICATION Nut, connection for terminal designation 50 *BA15.30-P-1002-01J 
9 Remove starter (M1) from below    
INSPECT Check     
10 Check ring gear at the drive plate for wear and damage When replacing the starter (M1)
IMPORTANT Rotate engine at center Bolt, crankshaft in the direction of engine rotation.
If necessary:
↓
Replace drive plate.
 
AR03.30-P-8001GZA
11 Install in the reverse order    
STARTER

Number Designation ENGINE 272, 273
BA15.30-P-1001-01J Nut, connection for terminal designation 30 Nm 15
STARTER

Number Designation ENGINE 272, 273
BA15.30-P-1002-01J Nut, connection for terminal designation 50 Nm 8
STARTER

Number Designation ENGINE 272, 273
BA15.30-P-1003-01J Bolt, starter to crankcase Nm 40