LEMON Manuals: Even more car manuals for everyone

Remove/install ignition coils - AR15.12-P-2003GZS

ENGINE 156 in MODEL 164, 251 

MODIFICATION NOTES

6.8.09 Value changed: screw/bolt, ignition coil to cylinder head cover BA15.10-P-1001-04B
21.8.12 Screw ignition on cylinder head cover BA15.10-P-1001-04B
Fig 1: Identifying Ignition Coils Remove/Install Components
G10115365Courtesy of MERCEDES-BENZ USA
REMOVINGINSTALLING Remove/install     
DANGER Risk of death  caused by contact with parts conducting high voltages. Do not touch parts which conduct high voltages. Persons who have electronic implants (e.g. cardiac pacemakers) should never perform any work on the ignition system. AS15.10-Z-0001-01A
DANGER Risk of injury.  Skin or eye injuries may result when handling hot or glowing objects. Wear protective gloves, protective clothing and safety glasses, if necessary. AS00.00-Z-0002-01A
NOTES Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
NOTES Notes on avoiding damage to ignition system   AH15.10-P-0002-01D
DANGER Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
1 Open engine hood and raise to vertical position MODEL 164 with ENGINE 156 AR88.40-P-1000GZ
    MODEL 251 with ENGINE 156 AR88.40-P-1000RT
2 Remove partition wall between wheel wells MODEL 251 with ENGINE 156  
AR62.30-P-2400RT
3 Remove air filter housing Remove/install air filter housing AR09.10-P-1150GZS
4 Detach electrical feed lines from cylinder 1 ignition coil to cylinder 8 ignition coil (T1/1 to T1/8) at ignition coil INSTALLATION IMPORTANT Replace cable tie.  
5 Unlock electrical connections (2) for cylinder 1 ignition coil to cylinder 8 ignition coil (T1/1 to T1/8) and detach    
6 Remove screw/bolt (3) TORQUE SPECIFICATION Screw/bolt, ignition coil to cylinder head cover *BA15.10-P-1001-04B 
7 Remove cylinder 1 ignition coil to cylinder 8 ignition coils (T1/1 to T1/8)    
8 Install in the reverse order    
DANGER Risk of accident  from vehicle starting off by itself when engine running. Risk of injury  (bruises and burns) resulting from working on the engine while it is being started or when it is running. Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. AS00.00-Z-0005-01A
9 Carry out an engine test run    
IGNITION COIN

Number Designation ENGINE 156, 159
BA15.10-P-1001-04B Screw/bolt, ignition coil to cylinder head cover Nm 6