LEMON Manuals: Even more car manuals for everyone

Continuity Inspection

NOTE:
  • The up position switch is built into the selector lever component.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Selector lever knob (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION .)
    2. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION .)
  3. Disconnect the selector lever component connector.
    G14589512Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between selector lever component terminals C and H.
    G15640712Courtesy of MAZDA MOTORS CORP.
    UP SWITCH SPECIFICATION

    Test condition Continuity
    Selector lever is in the M position (+) side position. Continuity
    Selector lever is not in the M position (+) side position. No continuity