Diagnostic Procedure
FAST IDLE/RUNS ON (SKYACTIV-G) DIAGNOSTIC PROCEDURE
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | VERIFY IF MALFUNCTION CAUSED BY COOLING SYSTEM OPERATION MALFUNCTION
|
Yes | Go to the next step. |
| No | [ECT] PID value is higher than 112°C {233°F}:
|
||
| 2 | VERIFY PCM DTCs
|
Yes | Repair or replace the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (SKYACTIV-G)] .) |
| No | Go to the next step. | ||
| 3 | VERIFY CURRENT INPUT SIGNAL STATUS
WARNING:
|
Yes | Go to the next step. |
| No | Inspect the suspected sensor and related wiring harness.
|
||
| 4 | VERIFY IF MALFUNCTION CAUSED BY A/C REQUEST SIGNAL MALFUNCTION
|
Yes | Go to the next step. |
| No | If the [A/C REQ] PID is always [Yes]:
|
||
| 5 | DETERMINE IF MALFUNCTION CAUSE IS DRIVE-BY-WIRE CONTROL SYSTEM OR OTHER
|
Yes | Go to Step 7. |
| No | Go to the next step. | ||
| 6 | INSPECT DRIVE-BY-WIRE CONTROL SYSTEM OPERATION
|
Yes | Visually inspect the throttle body (damage/scratching). If there is any malfunction:
|
| No | Repair or replace the malfunctioning location and perform the repair completion verification 1. | ||
| 7 | INSPECT FUEL INJECTOR OPERATION
|
Yes | Go to the next step. |
| No | Repair or replace the malfunctioning location and perform the repair completion verification 1. | ||
| 8 | INSPECT HIGH PRESSURE FUEL PUMP
|
Yes | Go to the next step. |
| No | Repair or replace the malfunctioning location and perform the repair completion verification 1. (Refer to HIGH PRESSURE FUEL PUMP REMOVAL/INSTALLATION [SKYACTIV-G 2.0] in service information.) |
||
| 9 | VERIFY IF MALFUNCTION CAUSED BY AIR SUCTION IN INTAKE AIR SYSTEM
|
Yes | Repair or replace the malfunctioning location and perform the repair completion verification 1. |
| No | A malfunction in the fuel injector control driver can be considered.
|
||
| Repair completion verification 1 | VERIFY THAT VEHICLE IS REPAIRED
|
Yes | Complete the symptom troubleshooting. (Explain contents of repair to customer) |
| No | Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .)
|