LEMON Manuals: Even more car manuals for everyone

Fuel Pump (Low-pressure Side) Operation Inspection

  1. Connect the M-MDS to the DLC-2.
  2. Remove the fuel-filler cap.
  3. Switch the ignition ON (engine off).
  4. Turn the fuel pump relay from off to on using the [FUEL_PUMP_REQ] simulation item and inspect if the operation sound of the fuel pump is heard. (See SIMULATION INSPECTION .)
    • If operation sound is heard, fuel pump is normal.
    • If no operation sound is heard, proceed to the next step.
  5. Measure the voltage at the wiring harness side fuel pump unit terminal A with the [FUEL_PUMP_REQ] PID turned on.
    • If the voltage is as specified, inspect the following:
      • Fuel pump continuity
      • Fuel pump ground
      • Wiring harness between the fuel pump relay and PCM terminal 2AW
    • If not as specified, inspect the following:
      • Fuel pump relay (Refer to [RELAY INSPECTION ] in service information.)
      • Wiring harness connector (DC-DC converter (i-ELOOP)-Fuel pump relay-Fuel pump unit) (With i-ELOOP)
      • Wiring harness connector (Battery-Fuel pump relay-Fuel pump unit) (Without i-ELOOP)

      Specification 

      8.0-11.5 V (Ignition switched ON)