Action for Non-repeatable Malfunction: Notes
- If the malfunction does not recur, perform the following inspection.
- Perform the DTC inspection and repair or replace the malfunctioning location according to the applicable DTC troubleshooting. (See DTC INSPECTION .)
- Based on the repair order form, attempt to drive the vehicle or perform tests to determine the malfunction cause according to the data (such as module voltage) at that time.
- Perform vibration inspection. (See VIBRATION INSPECTION .)
- Inspect the female terminals on the connector of the electric component which is suspected to be the cause of the malfunction for poor connection. (Refer to appropriate ELECTRICAL SYSTEM in the service information
.)NOTE:
- SST (reference): Probe kit (49US 15 1A0)
SPECIAL SERVICE TOOL DESCRIPTIONSST 49US 15 1A0 - Verify if the malfunction symptom occurs during high electric load (switches such as headlights, A/C, wipers are on).
- If a commercially-available electrical device has been installed, verify if the malfunction symptom occurs while the device is removed.
- Warm the electric system components using a hair dryer and verify that the voltage (resistance) does not change.
- Perform water spraying inspection. (See WATER SPRAYING INSPECTION .)