LEMON Manuals: Even more car manuals for everyone

Snapshot Data Table

SNAPSHOT DATA (PCM - SKYACTIV-G)

Snapshot data item Unit Data contents
ALT_VOLT_OUT_ACT V Generator output voltage
AMB_AIR_TEMP °C, °F Ambient temperature
APP1 % Accelerator pedal opening angle (absolute value) input from APP sensor No. 1
APP2 % Accelerator pedal opening angle (absolute value) input from APP sensor No. 2
BARO kPa {MPA}, mBar {BAR}, psi, in H20 Actually measured barometric pressure input from BARO sensor built into PCM
BATT_RES mOhm Battery inferred internal resistance
CAT_TEMP °C, °F Catalytic converter temperature
CLR_DTC_DIST km, ft, mi Mileage after DTC cleared
DSD_ALT_CUR A Generator current desired
ECT °C, °F Engine coolant temperature input from ECT sensor No. 1
ECT_SEN1_SUPPORT No/Yes ECT sensor No. 1 support
ECT_SEN2_SUPPORT No/Yes ECT sensor No. 2 support
ECT1 °C, °F Engine coolant temperature input from ECT sensor No. 1
ECT2 °C, °F Engine coolant temperature input from ECT sensor No. 2
EGR_COMD % Target EGR valve position
ENG_RPM Rpm Engine rotation speed
ENG_RUN_TIME s Time from engine start
EQUIVALENCE_RATIO_COMD Undefined/Not Used Target excess air factor (estimated value) to theoretical air/fuel ratio (14.7) by fuel feedback control
EVA_PRG_COMD % Purge solenoid valve controlled value
FLI % Fuel level
FRP kPa {MPA}, mBar {BAR}, psi, in H20 Fuel distributor pressure
FRP_GAUGE kPa {MPA}, mBar {BAR}, psi, in H20 Fuel distributor pressure (adjustment value)
FTP Pa Fuel tank pressure
FUEL_PRES kPa {MPA}, mBar {BAR}, psi, in H20 Fuel pressure (absolute) input from fuel pressure sensor
FUEL_PRES_COMD kPa {MPA}, mBar {BAR}, psi, in H20 Target fuel pressure (high pressure fuel pump)
FUEL_PRES_COMD_SUPPORT No/Yes Presence/non-presence of target fuel pressure (high pressure fuel pump)
FUEL_PRES_SUPPORT No/Yes Presence/non-presence of fuel pressure input from fuel pressure sensor
FUEL_RAIL_TEMP °C, °F Fuel distributor temperature
FUEL_RAIL_TEMP_SUPPORT No/Yes Presence/non-presence of fuel distributor temperature
FUELSYS_CL Yes/No Feedback status of fuel injection control
  • During feedback control by A/F sensor and HO2S
FUELSYS_CL_FAULT Yes/No Feedback status of fuel injection control
  • During feedback control with either A/F sensor or HO2S having a malfunction
FUELSYS_OL Yes/No Feedback status of fuel injection control
  • Feedback control is disabled at cold engine start
FUELSYS_OL_DRIVE Yes/No Feedback status of fuel injection control
  • While feedback control is stopped
FUELSYS_OL_FAULT Yes/No Feedback status of fuel injection control
  • Feedback control is disable due to system malfunction
GLOBAL_REAL_TIME min Accumulated total elapsed time since vehicle completion until PCM detects a DTC
HV_EV_BATT_SOC % Mazda M Hybrid battery charge condition
IAT °C, °F Intake air temperature input from IAT sensor No. 1
IAT1 °C, °F Intake air temperature input from IAT sensor No. 1
IAT2 °C, °F Intake air temperature input from IAT sensor No. 2
IAT3 °C, °F Intake air temperature input from IAT sensor No. 3
LOAD % Ratio (absolute value) of actual amount of intake air to the maximum air charging amount (mass volume) of cylinder
LOAD_CALC % Ratio (calculated value) of actual amount of intake air to the maximum air charging amount (mass volume) of cylinder
LONG_FUEL_TRIM % Fuel learning correction amount estimated based on A/F sensor signal
LONG_FUEL_TRIM_HO2S_SEN % Fuel learning correction amount estimated based on HO2S signal
MAF g/s Mass air flow input from MAF sensor
MAP kPa {MPA}, mBar {BAR}, psi, in H20 Manifold absolute pressure input from MAP sensor
NUM_WARM_UP_SINCE_DTC_CLR Count Number of warm-up cycle after DTC cleared
SHRT_FUEL_TRIM % Fuel feedback correction amount estimated based on A/F sensor signal
SHRT_FUEL_TRIM_HO2S_SEN % Fuel feedback correction amount estimated based on HO2S signal
SPARK_ADV °(deg) Ignition timing (BTDC)
THRO_ACTAT_COMD % Throttle valve actuator operation status
TOTAL_DIST km, ft, mi Accumulated total traveled distance from completion of vehicle until PCM detects a DTC
TP_RELAT % Throttle valve opening angle (relative value) with value at throttle valve fully close timing as the start point
TP1 % Throttle valve position No. 1
TP2 % Throttle valve position No. 2
TYPE_FUEL_UTILIZED Gasoline/petrol/Methanol/Ethanol/Diesel/Liquefied Petroleum Gas (LPG)/Compressed Natural Gas (CNG)/Propane/Battery/electric/Bi-fuel vehicle using gasoline/Bi-fuel vehicle using methanol/Bi-fuel vehicle using ethanol/Bi-fuel vehicle using LPG/Bi-fuel vehicle using CNG/Bi-fuel vehicle using propane/Bi-fuel vehicle using battery/Bi-fuel vehicle using battery and combustion engine/Hybrid vehicle using gasoline engine/Hybrid vehicle using gasoline engine on ethanol/Hybrid vehicle using diesel engine/Hybrid vehicle using battery/Hybrid vehicle using battery and combustion engine/Hybrid vehicle in regeneration mode Type of fuel currently being utilized by the vehicle
VPWR V PCM power supply voltage
VSS Kph, Mph Vehicle speed