DTC P0685-00: Main Relay Control Circuit Open
P0685-00: (PCM (SKYACTIV-G)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Main relay control circuit open |
| Detection condition |
- The period of time in which the PCM power supply remains on after the ignition is switched off is not within the specified time.
|
| Fail-safe |
|
| Possible cause |
- Main relay malfunction (Refer to [RELAY INSPECTION
] in service information.)
- Malfunction in wiring harness (including connector/terminal) between battery and DC-DC converter (i-ELOOP) (With i-ELOOP) (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- Malfunction in wiring harness (including connector/terminal) between DC-DC converter (i-ELOOP) and main relay (With i-ELOOP) (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- Malfunction in wiring harness (including connector/terminal) between battery and main relay (Without i-ELOOP) (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- Malfunction in wiring harness (including connector/terminal) between main relay and PCM (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- Malfunction in wiring harness (including connector/terminal) between PCM and body ground (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- PCM malfunction (Refer to PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0]
in service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Start the engine and warm it up completely.
|
Courtesy of MAZDA MOTORS CORP.
|
| 1 |
Battery |
| 2 |
Without i-ELOOP |
| 3 |
Main relay |
| 4 |
PCM |
| 5 |
DC-DC converter (i-ELOOP) |
| 6 |
With i-ELOOP |