LEMON Manuals: Even more car manuals for everyone

Rear Door Latch And Lock Actuator Removal/Installation: Notes

  1. Fully lower the rear door glass.
  2. Operate the door lock actuator using the following procedure and deplete the energy stored in the backup power supply.
    NOTE:
    • If the energy stored in the backup power supply has already been depleted, the door lock actuator does not operate. As this does not indicate an improper procedure, continue to perform the procedure as indicated.
    1. Remove the D.LOCK 25A fuse.
    2. Close the front door (driver's side)
    3. Repeat the lock/unlock operation of the door lock switch (driver's side) until all the door lock knobs do not move.
  3. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  4. Remove the following parts:
    1. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
    2. Glass guide (See REAR DOOR QUARTER GLASS REMOVAL/INSTALLATION .)
    3. Rear door speaker (See REAR DOOR SPEAKER REMOVAL/INSTALLATION .)
    4. Rear power window motor (See POWER WINDOW MOTOR REMOVAL/INSTALLATION .)
    5. Rear inner handle (See INNER HANDLE REMOVAL/INSTALLATION .)
  5. Press the center of the service hole cover in the direction of arrow (1) shown in the figure.
    G12236274Courtesy of MAZDA MOTORS CORP.
  6. Remove the service hole cover by holding its rib and partially peeling it back in the direction of arrow (2) shown in the figure.
  7. Remove the bolt.
    CAUTION:
    • If the bolts are removed without supporting the rear door glass, the rear door glass may fall off and be damaged. Remove the bolts while inserting your hand into the rear door speaker installation hole to support the rear door glass.
    Fig 1: Rear Door Latch And Lock Actuator Bolts With Torque Specification
    G12236275Courtesy of MAZDA MOTORS CORP.
  8. Raise the rear door glass to a position allowing removal of the rear door latch and lock actuator.
    G12236276Courtesy of MAZDA MOTORS CORP.
  9. Temporarily install the rear power window motor.
    G12236277Courtesy of MAZDA MOTORS CORP.
  10. Disconnect the connector.
    G12236278Courtesy of MAZDA MOTORS CORP.
  11. Remove the door lock knob cable and the inner handle cable from the clip. (See INNER HANDLE CABLE INSTALLATION NOTE .)
  12. Remove the screws.
    Fig 2: Rear Door Latch And Lock Actuator Screws With Torque Specification
    G12236279Courtesy of MAZDA MOTORS CORP.
  13. Tilt the rear door latch and lock actuator in the direction of arrow (1) shown in the figure and lift it in the direction of arrow (2) to detach the hook of the rear door latch and lock actuator.
    G12236280Courtesy of MAZDA MOTORS CORP.
  14. Move the rear door latch and lock actuator down in the direction of arrow shown in the figure to remove the rod from the rod holder.
    G12236281Courtesy of MAZDA MOTORS CORP.
  15. Remove the rear door latch and lock actuator.
  16. Install in the reverse order of removal.