LEMON Manuals: Even more car manuals for everyone

Remote Tuner (Rt) Removal/Installation: Sedan-4SD

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
  2. Remove the following parts:
    1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    3. Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    4. Rear seat back (See REAR SEAT BACK REMOVAL/INSTALLATION .)
    5. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    6. Rear package trim (See REAR PACKAGE TRIM REMOVAL/INSTALLATION .)
  3. Remove the nuts.
    Fig 1: Remote Tuner (RT) Nuts With Torque Specification
    G13718350Courtesy of MAZDA MOTORS CORP.
  4. Remove the wiring harness clip.
    G13718351Courtesy of MAZDA MOTORS CORP.
  5. Disconnect the connectors.
  6. When removing the bracket A and B, perform the following procedure:
    1. Remove the screws.
      G13718352Courtesy of MAZDA MOTORS CORP.
    2. Remove the bracket A.
    3. Remove the screws.
    4. Remove the bracket B.
  7. Install in the reverse order of removal.
  8. If the remote tuner is replaced, contact Sirius XM dealer support and tell them the radio ID and VIN. (With Sirius XM satellite radio) (See RADIO ID VERIFICATION PROCEDURE .)