LEMON Manuals: Even more car manuals for everyone

Leakage Inspection

WARNING:
  • Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or death and damage. To prevent this, complete the following inspection with the engine stopped.
  1. Follow "BEFORE SERVICE PRECAUTION" before performing any work operations to prevent fuel from spilling from the fuel system. (See BEFORE SERVICE PRECAUTION .)
  2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  4. Remove the fuel injector and fuel distributor as a single unit. (See FUEL INJECTOR REMOVAL/INSTALLATION .)
  5. Fix the fuel injector to the fuel distributor with a wire or the equivalent.
    Fig 1: Fixing Fuel Injector To Fuel Distributor With Wire
    G06150910Courtesy of MAZDA MOTORS CORP.
  6. Connect the fuel hose.
  7. Start the fuel pump using the following procedure:

    Using M-MDS 

    • Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)\
    • Connect the M-MDS to the DLC-2.
    • Start the fuel pump using the "FP" simulation function of the M-MDS.
      Fig 2: DLC-2
      G06150911Courtesy of MAZDA MOTORS CORP.

    Without using M-MDS 

    • Short the check connector terminal F/P to ground using a jumper wire.
      Fig 3: Locating Check Connector
      G06150912Courtesy of MAZDA MOTORS CORP.
    • Turn the ignition switch to the ON position to operate the fuel pump.
      NOTE:
      Fig 4: Check Connector Terminal F/P
      G06150913Courtesy of MAZDA MOTORS CORP.
  8. Tilt the fuel injector at an angle of 24  ° to inspect for leakage.
    Fig 5: Tilting Fuel Injector Angle
    G06150914Courtesy of MAZDA MOTORS CORP.

    Fuel injector leakage amount 

    Less than 1 drop/2 min 

  9. Stop the fuel pump using the following procedure:

    Using M-MDS 

    • Stop the fuel pump using the "FP" simulation function of the M-MDS.

    Not using M-MDS 

    • Turn the ignition switch to off to stop the fuel pump.
  10. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  11. Remove the wire or equivalent securing the fuel injector.
  12. Install the fuel injector and fuel distributor as a single unit. (See FUEL INJECTOR REMOVAL/INSTALLATION .)
  13. Complete the "AFTER SERVICE PRECAUTION". (See AFTER SERVICE PRECAUTION .)