LEMON Manuals: Even more car manuals for everyone

Back-Up Light Switch Removal/Installation

  1. Disconnect the negative battery cable.
  2. Disconnect the back-up light switch connector.
  3. Remove the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
  4. Remove the back-up light switch.
  5. Install the back-up light switch to the transaxle case.

    Tightening torque 

    29-52 N.m {2.9-5.3 kgf.m, 21-38 ft.lbf} 

  6. Install the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
  7. Connect the negative battery cable.
    Fig 1: Identifying Back-Up Light Switch Connector
    G06732722Courtesy of MAZDA MOTORS CORP.