LEMON Manuals: Even more car manuals for everyone

Driver Side

  1. Switch the ignition to off.
  2. Disconnect the negative battery cable and wait for 1min or more. 
  3. Remove the front scuff plate. (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
  4. Remove the rear scuff plate. (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
  5. Remove the B-pillar lower trim. (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
  6. Remove the fastener.
  7. Remove the cover.
    Fig 1: Identifying Lap Pre-Tensioner Seat Belt, Front Seat Belt, Cover And Fastener
    G06731695Courtesy of MAZDA MOTORS CORP.
  8. Remove the bolt A.
    Fig 2: Removing Lap Pre-Tensioner Seat Belt Bolt With Torque Specifications
    G06731696Courtesy of MAZDA MOTORS CORP.
  9. Remove the bolt B.
  10. Remove the front seat belt.
  11. Using a flathead screwdriver, lift the locking device carefully, however do not remove it.
    Fig 3: Lifting Locking Device Using Flathead Screwdriver
    G06731697Courtesy of MAZDA MOTORS CORP.
  12. Disconnect the pre-tensioner seat belt connector.
  13. Disconnect the lap pre-tensioner seat belt connector.
  14. Install in the reverse order of removal.
  15. Switch the ignition to ON.
  16. Verify that the air bag system warning light illuminates for approx. 6 s  and goes out.
    • If the air bag system warning light dose not operate, refer to the on-board diagnostic system (air bag system) and perform inspection of the system. (See FLOWCHART .)
      Fig 4: Disconnecting Lap Pre-Tensioner Seat Belt Connector
      G06731698Courtesy of MAZDA MOTORS CORP.