LEMON Manuals: Even more car manuals for everyone

Neutral Switch Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
  2. Disconnect the negative battery cable.
  3. Remove the battery component, (ex: battery, battery tray and PCM component) (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
  4. Remove the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
  5. Drain the oil from the transaxle. (See TRANSAXLE OIL REPLACEMENT .)
  6. Disconnect the neutral switch connector and remove the neutral switch.
  7. Install the neutral switch (with a new gasket) to the transaxle case.

    Tightening torque 

    20-29 N.m {2.1-2.9 kgf.m, 15-21 ft.lbf} 

  8. Install the battery component, (ex: battery, battery tray and PCM component) (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
  9. Install the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
    Fig 1: Identifying Neutral Switch Connector, Neutral Switch And Gasket
    G06734201Courtesy of MAZDA MOTORS CORP.
  10. Add the specified amount and type of oil. (See TRANSAXLE OIL REPLACEMENT .)
  11. Install the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)