LEMON Manuals: Even more car manuals for everyone

Steering Gear - 4WD: Removal

CAUTION:
  • When repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components can result.
  1. Place the steering wheel in the straight-ahead position and remove the ignition key.
    • Rotate the steering wheel until the steering column locks into position.
  2. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
  3. Remove the power steering fluid cooler. See POWER STEERING FLUID COOLER 
  4. Loosen the tie-rod jam nuts.
  5. Remove the outer tie-rod end cotter pins and nuts.

    Tightening Torque: 70 Nm {7.1 kgf-m, 52 ft-lbf} (vehicles built through 12/2005) 80 Nm {8.2 kgf-m, 59 ft-lbf} (vehicles built after 12/2005) 

    • Discard the cotter Pins.
      Fig 1: Separating Outer Tie Rods From Wheel Knuckles
      G04309572Courtesy of MAZDA MOTORS CORP.
      CAUTION:
      • Do not damage the tie-rod boot when installing SST 211-001.
      NOTE:
      • Remove the adapter from the ball end of SST 211-001. Apply a small amount of grease to the tie-rod end stud and the ball of the special tool.
  6. Using SST 211-001, separate the outer tie rods from the wheel knuckles.
  7. Remove the outer tie rods.
    • Count and record the number of turns required to remove the outer tie-rod end.
  8. Remove the stabilizer bar and link. See STABILIZER BAR AND LINK .
    CAUTION:
    • Do not allow the steering column shaft to rotate while it is disconnected from the steering gear or damage to the clock-spring can result. If there is evidence that the steering column shaft has rotated, the clockspring must be removed and recentered. See CLOCKSPRING .
  9. Remove the lower steering column shaft bolt and disconnect the lower intermediate shaft from the gear.
    • Discard the lower steering column shaft bolt.
  10. Remove the clamp plate nut and disconnect the pressure and return lines.
    • Discard the O-ring seals.
      CAUTION:
      • Hold the tops of the steering gear-to-crossmember stud bolts to avoid damaging the steering gear fluid transfer tubes.
  11. Remove the 2 steering gear nuts and stud bolts.
    Fig 2: Disconnecting Pressure And Return Lines
    G04309573Courtesy of MAZDA MOTORS CORP.
  12. Rotate the steering gear control valve housing toward the front of the vehicle.
  13. Turn the steering gear input shaft to the right until the stop is reached.
    Fig 3: Turning Steering Gear Input Shaft
    G04309574Courtesy of MAZDA MOTORS CORP.
  14. Move the steering gear as far to the RH side of the vehicle as possible.
    Fig 4: Moving Steering Gear As Far To RH Side Of Vehicle
    G04309575Courtesy of MAZDA MOTORS CORP.
  15. Move the LH inner tie rod forward to clear the frame crossmember.
    Fig 5: Moving LH Inner Tie Rod Forward To Clear Frame Crossmember
    G04309576Courtesy of MAZDA MOTORS CORP.
  16. Remove the steering gear