LEMON Manuals: Even more car manuals for everyone

Seat Front Removal / Installation: Removal

WARNING:
  • The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
WARNING:
  • To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
  • If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
NOTE:
  • The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
  • The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats 

  1. Depower the SRS. See DEPOWERING AND REPOWERING .
  2. Position the seat to its forward most position.

    40 percent seat 

  3. Remove the rear bolts.
  4. Position the seat to its rearmost position.
  5. Remove the front bolts.
    Fig 1: Locating Safety Belt Pretensioner Electrical Connector
    G04310265Courtesy of MAZDA MOTORS CORP.
  6. Disconnect the safety belt buckle pretensioner electrical connector.
  7. Remove the 40 percent seat.

    60 percent seat 

    Fig 2: Locating Safety Belt Buckle Anchor Bolt Cover
    G04310262Courtesy of MAZDA MOTORS CORP.
  8. Pull up and slide the safety belt buckle anchor bolt cover up the safety belt.
  9. Remove the center safety belt buckle anchor bolt.
  10. Remove the rear bolts.
  11. Position the seat to its rearward most position.
  12. Remove the front bolts.
    Fig 3: Locating Strap
    G04310263Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • The 2-door, regular cab and the 4-door cab plus safety belts route differently. Note belt position for correct installation.
  13. Route the center safety belt buckle through the locating strap on the side of the seat.
    Fig 4: Locating Safety Belt Pretensioner Electrical Connector
    G04310265Courtesy of MAZDA MOTORS CORP.
  14. Disconnect the safety belt pretensioner electrical connector.
  15. Remove the 60 percent seat from the vehicle.