LEMON Manuals: Even more car manuals for everyone

Steering Angle Sensor Inspection

  1. Remove the column cover.
  2. Turn the ignition switch to the ON position and measure the voltage between steering angle sensor terminal A and ground.
    • If there is any malfunction, inspect the wiring harness between steering angle sensor terminal A and ignition switch. Repair or replace if necessary.
      Fig 1: Identifying Steering Angle Sensor Connector Terminals
      G04314659Courtesy of MAZDA MOTORS CORP.

    Standard voltage 

    B+ 

  3. Measure the voltage between steering angle sensor terminal D and ground.
    • If there is any malfunction, inspect the wiring

      harness between steering angle sensor terminal D and EHPAS control module terminal 3A. Repair or replace if necessary.

      Standard voltage 

      O V 

  4. Turn the ignition switch off.
  5. Connect the WDS or equivalent to the DLC-2.
  6. Select the "STEER_RATE" PID.
  7. Verify the STEER_RATE changes when the steering wheel is turned to the left and right.
    • If there is any malfunction, replace the steering angle sensor. (See CLOCK SPRING REMOVAL/INSTALLATION ).

      Standard 

      When the steering wheel is turned to the left: 

      SWA POS changes positively. 

      When the steering wheel is turned to the right: 

      SWA POS changes negatively. 

      Fig 2: Locating Connector DLC-2
      G04315543Courtesy of MAZDA MOTORS CORP.