No. 15 Emission Compliance
POSSIBLE CAUSE
| 15 | EMISSION COMPLIANCE |
|---|---|
| DESCRIPTION | Fails emissions test. |
| POSSIBLE CAUSE |
WARNING:
The following troubleshooting flow chart contains fuel system diagnosis and repair procedures. Read following warnings before servicing fuel system:
CAUTION:
|
DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | RESULTS | ACTION |
|---|---|---|---|
| 1 | Inspect for the following:
Are all items normal? |
Yes | Go to the next step. |
| No | Service if necessary. Repeat Step 1. |
||
| 2 | Connect the WDS or equivalent to the DLC-2. Turn the ignition switch to the ON position (Engine off). Retrieve any DTCs. Are there any DTCs displayed? |
Yes | DTC is displayed: Go to appropriate DTC inspection. (See DTC TABLE ). |
| No | No DTC is displayed: Go to the next step. |
||
| 3 | Is any other driveability concern present? | Yes | Go to appropriate symptom troubleshooting. |
| No | Go to the next step. | ||
| 4 | Connect the WDS or equivalent to the DLC-2. Access ECT PID. Warm up the engine and idle it. Verify ECT PID is correct. (See PCM INSPECTION ). Is ECT PID correct? |
Yes | Go to the next step. |
| No | Inspect for coolant leakage, cooling fan and condenser fan operation or thermostat operation. | ||
| 5 | Inspect fuel-filler cap. (See FUEL-FILLER CAP INSPECTION ). Is there any leakage at fuel-filler cap? |
Yes | Replace the fuel-filler cap. |
| No | Go to the next step. | ||
| 6 | Inspect the front HO2S. (See HEATED OXYGEN SENSOR (HO2S) INSPECTION ). Is front HO2S normal? |
Yes | Go to the next step. |
| No | Replace the front HO2S. (See HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION ). |
||
| 7 | Perform spark test. (See SPARK TEST ). Is strong blue spark visible at each cylinder? |
Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part according to spark test result. | ||
| 8 | Install the fuel pressure gauge between the fuel pipe and the fuel distributor. Start the engine and idle it. Measure fuel line pressure during idle. Is fuel line pressure correct during idle? (See FUEL LINE PRESSURE INSPECTION ). |
Yes | Go to the next step. |
| No | Low: Inspect the fuel line for clogging. If there is no malfunction, replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION ). High: Replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION ). |
||
| 9 | Remove and shake the PCV valve. Does the PCV valve rattle? |
Yes | Go to the next step. |
| No | Replace the PCV valve. | ||
| 10 | Inspect for fuel saturation inside charcoal canister. Is excess amount of liquid fuel present in canister? |
Yes | Replace the charcoal canister. |
| No | Inspect the fuel tank vent system. Then, go to the next step. (See FUEL TANK INSPECTION ). |
||
| 11 | visually inspect the exhaust system part. Is there any deformed exhaust system part? |
Yes | Replace the part. |
| No | Go to the next step. | ||
| 12 | Inspect the three-way catalytic converter. (See EXHAUST SYSTEM INSPECTION ). Is the three-way catalytic converter normal? |
Yes | Inspect the EGR system. (See EGR CONTROL SYSTEM INSPECTION ). |
| No | Replace the three-way catalytic converter. | ||
| 13 |
|
||