LEMON Manuals: Even more car manuals for everyone

DTC P2405

DETECTION CONDITION AND POSSIBLE CAUSE (DTC P2405 - LF, L3)

DTC P2405 EVAP system leak detection pump sense circuit low input
DETECTION CONDITION 
  • The PCM monitors pump load current (EVAP line pressure), while evaporative leak monitor is operating. If the current is lower than the specification while the PCM obtains the reference current value, the PCM determines EVAP system leak detection pump orifice has a malfunction.
  • Diagnostic support note 

  • This is a intermittent monitor (CCM).
  • The MIL illuminates if PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while DTC for the malfunction has been stored in PCM.
  • PENDING CODE is available if PCM detects the above malfunction condition during first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTC is stored in PCM memory.
POSSIBLE CAUSE 
  • EVAP system leak detection pump orifice fallen off
  • EVAP system leak detection pump motor malfunction
  • PCM malfunction
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED 
  • Have FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS (CCM related) been recorded?
Yes Go to the next step.
No Record FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to available repair information.
  • If vehicle is not repaired, go to the next step.
No Replace the EVAP system leak detection pump, then go to the next step.
3 VERIFY TROUBLESHOOTING OF DTC P2405 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Perform the evaporative emission test using the WDS or equivalent.

    (See EVAP SYSTEM LEAK INSPECTION USING WDS OR EQUIVALENT ).

  • Is the same DTC present?
    NOTE:
    • If evaporative system test function is not available, perform the following procedure:
    • Perform the EVAP System Repair Verification Drive Mode.

      (See OBD-II DRIVE MODE ).

    • Is the PENDING CODE the same as the DTC present?
Yes Replace the PCM, then go to the next step.
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.