LEMON Manuals: Even more car manuals for everyone

DTC P2404

DETECTION CONDITION AND POSSIBLE CAUSE (DTC P2404 - LF, L3)

DTC P2404 EVAP system leak detection pump sense circuit problem
DETECTION CONDITION 
  • The PCM monitors pump load current (EVAP line pressure), while evaporative leak monitor is operating. After obtaining the reference current value, if the time in which the pump load current reaches the reference current value is less than the specification, the PCM determines air filter has a malfunction.
  • Diagnostic support note 

  • This is a intermittent monitor (CCM).
  • The MIL illuminates if PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while DTC for the same malfunction has been stored in PCM.
  • PENDING CODE is available if PCM detects the above malfunction condition during first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTC is stored in PCM memory.
POSSIBLE CAUSE 
  • Air filter clogging
  • EVAP hose bending
  • PCM malfunction
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED 
  • Have FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS (CCM related) been recorded?
Yes Go to the next step.
No Record FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnostic according to available repair information.
  • If vehicle is not repaired, then go to the next step.
No Go to the next step.
3 INSPECT EVAP HOSE BENDING 
  • Inspect the EVAP hose for bending.
  • Is the EVAP hose normal?
Yes Go to the next step.
No Repair or replace the hose, then go to Step 5.
4 INSPECT AIR FILTER FOR CLOGGING 
  • Inspect the air filter for clogging.
  • Is the air filter normal?
Yes Go to the next step.
No Replace the air filter, then go to the next step.
5 VERIFY TROUBLESHOOTING OF DTC P2404 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Perform the evaporative system test using the WDS or equivalent.

    (See EVAP SYSTEM LEAK INSPECTION USING WDS OR EQUIVALENT ).

  • Is the same DTC present?
    NOTE:
    • If evaporative system test function is not available, perform the following procedure:
    • Perform the EVAP System Repair Verification Drive Mode.

      (See OBD-II DRIVE MODE ).

    • Is the PENDING CODE the same as the DTC present?
Yes Replace the PCM, then go to the next step.
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.