LEMON Manuals: Even more car manuals for everyone

DTC P2228

DETECTION CONDITION AND POSSIBLE CAUSE (DTC P2228 - LF, L3)

DTC P2228 BARO sensor circuit low input
DETECTION CONDITION 
  • The PCM monitors input voltage from BARO sensor into the PCM. If input voltage is below 2.1 V  (1) , 1.95 V  (2)  , PCM determines that BARO sensor circuit has malfunction.
  • Diagnostic support note 

  • This is a continuous monitor (CCM).
  • The MIL illuminates if PCM detects the above malfunction condition during first drive cycle.
  • PENDING CODE is available if PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is available.
  • DTC is stored in PCM memory.
POSSIBLE CAUSE 
  • BARO sensor malfunction
  • PCM malfunction
(1) California emission regulation applicable model
(2) Except for California emission regulation applicable model
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT BARO SENSOR MALFUNCTION  Yes Go to the next step.
No Replace the PCM, then go to the next step.
4 VERIFY TROUBLESHOOTING OF DTC P2228 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Turn the ignition switch to the ON position (Engine off).
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start the engine.
  • Is the same DTC present?
Yes Replace the PCM, then go to the next step.

(See PCM REMOVAL/INSTALLATION ).

No No concern is detected. Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE  Yes Go to applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.