DTC P2119
DETECTION CONDITION AND POSSIBLE CAUSE (DTC P2119 - LF, L3)
| DTC P2119 |
Throttle actuator control throttle body range/performance problem |
| DETECTION CONDITION |
California emission regulation applicable model
- The PCM compares the TP with the default TP when the ignition switch is off. If the different between TP is default TP is lower than threshold, the PCM determines that there is a throttle actuator control throttle body range/performance problem.
Diagnostic support note
- This is a continuous monitor (CCM).
- The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
- PENDING CODE is available if the PCM detects the above malfunction condition.
- FREEZE FRAME DATA is available.
- The DTC is stored in the PCM memory.
|
Except for California emission regulation applicable model
- The PCM compares the TP with the default TP when the ignition switch is off. If the TP is higher than the default TP, the PCM determines that there is a throttle actuator control throttle body range/performance problem.
Diagnostic support note
- This is a continuous monitor (CCM).
- The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
- PENDING CODE is available if the PCM detects the above malfunction condition.
- FREEZE FRAME DATA is available.
- The DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- Throttle actuator malfunction
- Throttle valve malfunction
- PCM malfunction
|
DIAGNOSTIC PROCEDURE CHART
| STEP |
INSPECTION |
ACTION |
| 1 |
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
- Has FREEZE FRAME DATA been recorded?
|
Yes |
Go to the next step. |
| No |
Record the FREEZE FRAME DATA on the repair order, then go to the next step. |
| 2 |
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
- Verify related Service Bulletins and/or on-line repair information availability.
- Is any related repair information available?
|
Yes |
Perform repair or diagnosis according to the available repair information.
- If the vehicle is not repaired, go to the next step.
|
| No |
Go to the next step. |
| 3 |
INSPECT THROTTLE ACTUATOR
|
Yes |
Replace the throttle body, then go to Step 5. (See
INTAKE AIR SYSTEM REMOVAL/INSTALLATION
). |
| No |
Go to the next step. |
| 4 |
INSPECT THROTTLE VALVE
|
Yes |
Replace the throttle body, then go to the next step. (See
INTAKE AIR SYSTEM REMOVAL/INSTALLATION
). |
| No |
Go to the next step. |
| 5 |
VERIFY TROUBLESHOOTING OF DTC P2119 COMPLETED
- Make sure to reconnect all disconnected connectors.
- Clear the DTC from the PCM memory using the WDS or equivalent.
- Turn the ignition switch to the ON position (Engine off), then off.
- Is the PENDING CODE for this DTC present?
|
Yes |
Replace the PCM, then go to the next step. (See
PCM REMOVAL/INSTALLATION
). |
| No |
Go to the next step. |
| 6 |
VERIFY AFTER REPAIR PROCEDURE
|
Yes |
Go to the applicable DTC inspection. (See
DTC TABLE
). |
| No |
DTC troubleshooting completed. |