LEMON Manuals: Even more car manuals for everyone

DTC P2109

DETECTION CONDITION AND POSSIBLE CAUSE (DTC P2109 - LF, L3)

DTC P2109 TP sensor minimum stop range/performance problem
DETECTION CONDITION 
  • The PCM monitors the minimum TP when the closed TP learning is completed. If the TP is less than 6.03%  or more than 18.7%,  the PCM determines that there is a TP sensor minimum stop range/performance problem.
  • Diagnostic support note 

  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
  • PENDING CODE is available if the PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Throttle actuator malfunction
  • Throttle valve malfunction
  • PCM malfunction
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT THROTTLE ACTUATOR  Yes Replace the throttle body, then go to Step 5. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION ).
No Go to the next step.
4 INSPECT THROTTLE VALVE  Yes Replace the throttle body, then go to the next step. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION ).
No Go to the next step.
5 VERIFY TROUBLESHOOTING OF DTC P2109 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start the engine.
  • Is the same DTC present?
Yes Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection. (See DTC TABLE ).
No DTC troubleshooting completed.