LEMON Manuals: Even more car manuals for everyone

DTC P0564

DETECTION CONDITION AND POSSIBLE CAUSE (DTC P0564 - LF, L3)

DTC P0564 Cruise control switch circuit malfunction
DETECTION CONDITION 
  • The PCM monitors the cruise control switch signal at PCM terminal 1AQ(1), 1AD(2), 1AQ*3. If the PCM detects that any one of following switches (Main, CANCEL, SET/COAST, RESUME/ACCEL) remains on for 2 min  , the PCM determines that the cruise control switch circuit has a malfunction.
  • Diagnostic support note 

  • This is a continuous monitor (Other).
  • MIL does not comes on.
  • PENDING CODE is available if PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is not available.
  • DTC is stored in PCM memory.
POSSIBLE CAUSE 
  • Cruise control switch malfunction
  • Connector or terminal malfunction
  • Short to power circuit in wiring from cruise control switch terminal A and PCM terminal 1AQ(1), 1AD(2)
  • Short to ground circuit in wiring from cruise control switch terminal A and PCM terminal 1AQ(1), 1AD(2)
  • PCM malfunction
G04313409Courtesy of MAZDA MOTORS CORP.
(1) LF MTX, L3 and California emission regulation applicable model with LF ATX
(2) Except for California emission regulation applicable model with LF ATX
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to available repair information.
  • If vehicle is not repaired, go to the next step.
No Go to the next step.
2 INSPECT CRUISE CONTROL SWITCH CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Inspect for poor connection (such as damaged, pulled-out terminals, corrosion).
  • Is there any malfunction?
Yes Repair or replace the terminal, then go to Step 6.
No Go to the next step.
3 INSPECT CRUISE CONTROL SWITCH SIGNAL CIRCUIT FOR SHORT TO GROUND 
  • Disconnect cruise control switch and PCM connectors.
  • Inspect for continuity between cruise control switch terminal A (wiring harness-side) and body ground.
  • Is there continuity?
Yes Repair or replace short to ground, then go to Step 6.
No Go to the next step.
4 INSPECT CRUISE CONTROL SWITCH SIGNAL CIRCUIT FOR SHORT TO POWER 
  • Turn the ignition switch to the ON position (Engine off).
  • Inspect the voltage between cruise control switch terminal A (wiring harness-side) and body ground.
  • Is the voltage below 1.0 V  ?
Yes Go to the next step.
No Repair or replace short to power supply, then go to Step 6.
5 INSPECT CRUISE CONTROL SWITCH OPERATION  Yes Go to the next step.
No Replace the cruise control switch, then go to the next step.
6 VERIFY TROUBLESHOOTING OF P0564 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Drive the vehicle with cruise control 2 min. or more  .
  • Is the same DTC present?
Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
7 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.