| 1 |
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
- Has FREEZE FRAME DATA been recorded?
|
Yes |
Go to the next step. |
| No |
Record the FREEZE FRAME DATA on the repair order, then go to the next step. |
| 2 |
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
- Verify related service Bulletins and/or on-line repair information availability.
- Is any related repair information available?
|
Yes |
Perform repair or diagnosis according to the available repair information.
- If the vehicle is not repaired, go to the next step.
|
| No |
Go to the next step. |
| 3 |
INSPECT FAN CONTROL MODULE CONNECTOR FOR POOR CONNECTION
- Turn the ignition switch off.
- Disconnect fan control module connector.
- Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
- Is there any malfunction?
|
Yes |
Repair or replace the terminal, then go to Step 9. |
| No |
Go to the next step. |
| 4 |
INSPECT FAN CONTROL MODULE SIGNAL CIRCUIT FOR SHORT TO POWER SUPPLY
- Turn the ignition switch to the ON position (Engine off).
- Measure the voltage between fan control module terminal B (wiring harness-side) and body ground.
- Is the voltage B+
?
|
Yes |
Repair or replace the wiring harness for open circuit, then go to Step 9. |
| No |
Go to the next step. |
| 5 |
INSPECT FAN CONTROL MODULE SIGNAL CIRCUIT FOR SHORT TO GROUND
- Turn the ignition switch off.
- Inspect for continuity between fan control module terminal B (wiring harness-side) and body ground.
- Is there continuity?
|
Yes |
Repair or replace the wiring harness for open circuit, then go to Step 9. |
| No |
Go to the next step. |
| 6 |
INSPECT PCM CONNECTOR FOR POOR CONNECTION
- Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
- Is there any malfunction?
|
Yes |
Repair or replace the terminal, then go to Step 9. |
| No |
Go to the next step. |
| 7 |
INSPECT FAN CONTROL MODULE SIGNAL CIRCUIT FOR OPEN CIRCUIT
- Inspect for continuity between fan control module terminal B (wiring harness-side) and PCM terminal 1Y, 1W, 1R.
- Is there continuity?
|
Yes |
Go to the next step. |
| No |
Repair or replace wiring harness for open circuit, then go to Step 9. |
| 8 |
INSPECT FAN CONTROL MODULE
|
Yes |
Go to the next step. |
| No |
Replace the fan control module, then go to the next step. |
| 9 |
VERIFY TROUBLESHOOTING OF DTC P0480 COMPLETED
- Clear the DTC from the PCM memory using the WDS or equivalent.
- Perform the KOEO or KOER self-test.
- Turn A/C switch to ON.
- Is the same DTC present?
|
Yes |
Replace the PCM, then go to the next step. (See
PCM REMOVAL/INSTALLATION
). |
| No |
Go to the next step. |
| 10 |
VERIFY AFTER REPAIR PROCEDURE
|
Yes |
Go to the applicable DTC inspection. (See
DTC TABLE
). |
| No |
Troubleshooting completed. |